SMSC USB464 - Manual (Page 9)

High Speed Inter-Chip USB 2.0 Hub and Flash Media Controller
Datasheet
SMSC USB4640/USB4640i 9 Revision 1.0 (06-01-09)
DATASHEET
OEM Selectable Hub Features
A default configuration is available in the USB4640/USB4640i following a reset. The
USB4640/USB4640i may also be configured by an external I
2 C EEPROM or via external SPI ROM
flash.
„
Compound Device support on a port-by-port basis
- a port is permanently hardwired to a downstream USB peripheral device
„
Select over-current sensing and port power control on an individual or ganged (all ports together)
basis to match the OEM’s choice of circuit board component selection
„
Port power control and over-current detection/delay features
„
Configure the delay time for filtering the over-current sense inputs
„
Configure the delay time for turning on downstream port power
„
Bus- or self-powered selection
„
Hub port disable or non-removable configurations
„
Flexible port mapping and disable sequencing supports multiple platform designs
„
Programmable USB differential-pair pin location eases PCB layout by aligning USB signal lines
directly to connectors
„
Programmable USB signal drive strength recovers USB signal integrity using 4 levels of signal drive
strength
„
Indicate the maximum current that the 2-port hub consumes
„
Indicate the maximum current required for the hub controller