Siemens TC63 - Manual (Page 348)

TC63 AT Command Set
13.17 AT+CSMS
s
TC63_ATC_V00.490 Page 348 of 501 5/24/05
Confidential / Draft - Do not copy
Broadcast Type Messages:
0
Type not supported
1 Type supported
Notes
• If CSMS mode is switched from Phase 2+ to Phase 2 and one or more
AT+CNMI
Parameter are Phase 2+
specific a '+CMS ERROR: unknown error' will appear. It is recommended to switch the
AT+CNMI
Parameters
to Phase 2 specific values before entering Phase 2.
• Phase 2+ (
<service>
=1) must be set before the following features can be used:
- Configuring procedures for indicating received short messages with the
AT+CNMI
parameters
<mt>
=2 or
<mt>
=3 and
<ds>
=1.
- Acknowledging incoming short messages with
AT+CNMA
.
- Receiving Status Reports and acknowledging them with
AT+CNMA
.
<bm>
(num)