Siemens TC63 - Manual (Page 97)

TC63 AT Command Set
4.7 AT+IFC
s
TC63_ATC_V00.490 Page 97 of 501 5/24/05
Confidential / Draft - Do not copy
Notes
• When using XON/XOFF flow control (
AT+IFC
=1,x or
AT+IFC
=3,x) in data mode,
+++
should not be used
while the data transmission is paused with XOFF. Before entering the command mode with
+++
the paused
transmission should be resumed using the XON character.
• For compatibility reasons, the
AT+IFC
command can be used in Multiplex mode, though the settings will not
take effect. However, be aware that whenever you use the
AT+IFC
write command in Multiplex mode and
then save the current configuration to the user profile with
AT&W
, the changed
AT+IFC
setting will become
active after restart.