SUPER MICRO Computer SUPERO H8QG6+-F - Manual (Page 50)

H8QG6/i+-F Serverboard User's Manual
2-24
Figure 2-5.Adaptec RAID Utility Program Screen
Using the Adaptec RAID Utility
The Adaptec® RAID Utility program is where you can defi ne the drives you want
to include in the RAID array and the mode and type of RAID.
Installing the RAID Driver During OS Installation
You may also use the procedure below to install the RAID driver during the Window's
OS installation:
1. With the Windows OS installation CD in the CD-ROM drive, restart the
system.
2. When you see the prompt, hit the <F6> key to enter Windows setup.
3. Eventually a blue screen will appear with a message that begins "Windows
could not determine the type of one or more storage devices . . ." When you
see the screen, hit the <S> key to "Specify Additional Device", then insert the
driver diskette you just created into the fl oppy drive.
4. Highlight "Manufuacturer Supplied Hardware Support Disk" and hit the
<Enter> key.
5. Highlight the fi rst "Adaptec RAID" driver shown and press the <Enter> key to
install it.
6. Press <Enter> again to continue with the Windows setup.