SMC Networks SMC8014W-G - Manual (Page 23)

1. You will need to confirm the network is setup with a valid Public LAN IP in [LAN] page
before they enable the RIP setting.
NOTE: The RIP setting is disabled by default.
2. After you confirm the LAN Settings, then you will need to configure the RIP Settings.
These settings will need to be configured based on how your cable operator network is set up.
WIRELESS
This section allows you to configure the Gateway’s built-in 54 Mbps 802.11g Access Point. To
setup the wireless connections, you will need to do define the Service Set Identifier (SSID),
Channel, Encryption options, and other optional settings.
To access the Wireless Settings page shown below, on the Side Navigation bar, click on
[Wireless] link.