Sony HDW-F500 - Manual (Page 161)

Appendix
A-33
Appendix
Item number Settable range Item
627 CHAR WARNING
DISPLAY at dual
line mode [off]
on
When item 626 is set to anything other than time data only,
this item specifies whether warning messages flash on the
second line or not.
off: Warning messages do not flash.
on: If a warning message exists, it flashes.
Notes
• Messages that have been cleared are not displayed. For
more information about clearing warning messages, see
“Clearing warning messages” on page A-9.
• When there are multiple warning messages, each
message flashes twice before it is replaced by the next
message.
628 REMAIN TIME
DISPLAY [off]
10min
on
Sets whether to display remaining time on the tape in
superimposed charecter position.
off: Do not display remaining time.
10 min: Display remaining time when it is 10 minutes or
less.
on: Always display remaining time.
Notes
The remaining time on the tape is not displayed when no
cassette is inserted. The remaining time is not also
displayed until the VTR finishes detecting the diameter of
the wound tape and estimating the remaining time
immediately after the cassette is inserted.
Function
630 TC CONVERSION
at 25F off-speed
PB [off]
on
Specifies whether or not to convert the 24 frames time code
to the 25 frames time code when off-speed playing back the
cassette tape recorded in the 24F mode with the 25F mode.
off: Does not convert the 24 frames time code to the 25
frames time code.
on: Converts the 24 frames time code to the 25 frames time
code.
Note
This setting is only active when the field frequency is 25 Hz.