Sony HDW-F500 - Manual (Page 73)

Chapter 4 Menu Settings
4-31
Chapter 4 Menu Settings
To display remaining time on the tape
Use the 628.REMAIN TIME DISPLAY to display
remaining time on the tape.
off: Do not display remaining time.
10min: Display remaining time when it is 10
minutes or less.
on: Always display remaining time.
Examples of remaining time display
Changing the superimpose position
The superimpose position can be set to 16 different
positions in the horizontal directions (0-15) and 24
different positions in the vertical directions (0-23).
1
Press the ALT/ [F7] (CHARA H-POS) button to
change the horizontal position and the [F8]
(CHARA V-POS) to change the vertical position.
The setting display part is lit.
2
Use the [<] and [>] buttons to change the value.
The + and – buttons can also be used.
3
Press the ALT/ [F7] (CHARA H-POS) button or the
[F8] (CHARA V-POS) button. The positions are
set and the setting display disappears.
The positions are also set if another menu is
selected.
4-3-12 Setting the VITC Insertion
Line (VITC POS-1/POS-2)
VITC signals can be inserted at two positions between
lines 12 and 20 in the output signal from the HD-SD
converter.
Setting the VITC insertion line (VITC POS-1/POS-2)
1
Press the ALT button, then the [F9] (VITC POS-1)
button.
The setting display part is lit.
2
Press the G or g button to change the value.
You can also use the + or – button.
3
Press the [F9] (VITC POS-1) button.
The data setting is completed and the setting
display disappears. Switching to another menu also
completes the setting display disappears.
Following the same steps but using the [F10] (VITC
POS-2) button, VITC can be inserted on another line.
T C R 2 3 5 9 4 0 1 8 . : : : *
T C R 2 3 5 9 4 0 1 8 . : : : *
T C R 2 3 5 9 4 0 1 8 . : : : *
R 2 3
R 5
R
- -
When remaining time is 23 minutes.
When remaining time is five minutes.
1,3 2
2 1,3
When remaining time is 100 minutes or over.