Sony HDW-F500 - Manual (Page 69)

Chapter 4 Menu Settings
4-27
Chapter 4 Menu Settings
6
Press the SET button to set the input data.
7
Press the [F2] (PDTIME SET) key.
Notes
• Once the time code is preset, it cannot be reverted.
• Operation information display cannot be displayed
while the pull down time code appears.
• The pull down time code cannot be displayed while
the machine-to-machine editing display appears.
4-3-9 Conversion of Time Code
When Playing Back in the 25F
Mode (TC CONV)
When the cassette tape recorded in the 24F mode is
played back in the 25F mode (off-speed playback), it is
possible to convert the 24 frames time code to the 25
frames time code. To set the conversion, press the
ALT/
[F3] (TC CONV) key.
off: Does not convert the 24 frames time code to the
25 frames time code.
on: Converts the 24 frames time code to the 25
frames time code.
The total amount of frames of the current time code is
calculated using 00H00M00S00F of the 24 frames
time code as a reference, and then it is converted to the
25 frames. For example, 00:00:10:20 of the 24 frames
time code is converted to 00:00:10:10 of the 25 frames
time code, and 23:59:50:00 to 23:59:50:10.
Note
• This setting is only active when the frame frequency
of the unit is 25 Hz.
• This setting is effective only for the VITC and time
code of SONY 9PIN protocol. From the TIME
CODE OUT connector, 24 frames time code is
output.
SET is
displayed.
C H . C O N D
G R E E N
P D P S E T
2 4 F T C
00
Ó
00
µ
00
ß
00
ƒ
3 0 F T C
00
Ó
00
µ
00
ß
00
ƒ
P D T I M E
S E T
R E M A I N - T
L 1 1 3 m i n
P D T C
D F / N D F
E X I T
D F
2 4 F
P R E S E T
M O D E
T C R 0 0 : 0 0 : 0 0 : 0 0
S E T 0 1 0 0 3 0 0 0
C H . C O N D
G R E E N
P D P S E T
2 4 F T C
01
Ó
00
µ
30
ß
00
ƒ
3 0 F T C
00
Ó
00
µ
00
ß
00
ƒ
P D T I M E
S E T
R E M A I N - T
L 1 1 3 m i n
P D T C
D F / N D F E X I T
D F
2 4 F
P R E S E T
M O D E
T C R 0 0 : 0 0 : 0 0 : 0 0