Sony WEGA KLV-30MR1 - Manual (Page 69)

69 Additional Information
GB
Troubleshooting
Here are some simple solutions to problems which may affect the picture and sound.
Problem Possible remedies
No picture
No picture (screen is dark) and no sound. • Check the aerial connection.
• Connect the display unit and media receiver unit to the mains,
and press the power switch on the front of media receiver
unit.
• Connect the display unit to the media receiver unit using the
supplied display interface cable.
• If the (power on/standby) indicator is on, press TV
on the remote control.
The TV turns off automatically. (The TV
enters the standby mode.) • Check if the Sleep Timer is activated (page 40).
• Check if the On/Off Timer is activated (page 42).
• Check if Auto Shutoff is activated (page 41).
No picture or no menu information from
equipment connected to the Scart
connector. • Check that the optional equipment is on and press the
button repeatedly on the remote control until the correct input
symbol is displayed on the screen.
• Check the connection between the optional equipment and
the TV.
Poor picture/Unstable picture.
Double images or ghosting. • Check aerial/cable connections.
• Check the aerial location and direction.
Only snow and noise appears on the
screen. • Check if the aerial is broken or bent.
• Check if the aerial has reached the end of its serviceable life.
(3-5 years in normal use, 1-2 years at the seaside)
Dotted lines or stripes. • Keep the TV away from electrical noise sources such as cars,
motorcycles, or hair-dryers.
No colour on colour programmes. • Using the menu system, select the “Picture Adjustment”
menu and select “Reset” to return to the factory settings
(page 27).
• If you set the Power Saving function to “Reduce,” picture
colours may become dimmer (page 33).
Some tiny black points and/or bright
points on the screen. • The picture of a display unit is composed of pixels. Tiny
black points and/or bright points (pixels) on the screen, do
not indicate a malfunction.
The picture is too bright. • Using the menu system, select the “Picture Adjustment”
menu and select “mode.” Then select the desired picture
mode (page 26).
Picture (stripe) noise. • Make sure that the aerial is connected using the supplied
coaxial cable.
• Keep the aerial cable away from other connecting cords.
• Do not use 300-ohm twin lead cables as interference may
occur.
Poor picture (white saturation) when
viewing a signal from Scart connector
3/ .
• Make sure that the output signal of the equipment connected
to the Scart connector 3/ is not an RGB signal. If it
is an RGB signal, please connect the equipment to Scart
1/ , 2/ or 4/ .
S
S
(continued)