Sony HK-PSU02 - Manual (Page 10)

1-4
MVE-8000A
Screws
(with drop-safe)
Front door assembly
Screws
(with drop-safe)
1-4. Installing the Options
The MVE-8000A-C is shipped from the factory with the
necessary option (refer to the following table) already
installed in the MVE-8000A, in accordance with the
specified system configuration.
MVE-8000A-C options
Model name Board configuration
Plug-in board Connector board
MKE-8020A _ CN-2153 board
MVS Interface Board
MKE-8040A DVP-30A board
Advanced Effects Board
HK-PSU02 _ _
Power Supply Unit
1-4-1. Installing the Plug-in Boards
c
Be sure to turn off the POWER switch and unplug the
power cord from the wall outlet before starting the installa-
tion work.
If the installation work is started with the POWER switch
left on, it may cause electrical shock or damage of printed
circuit boards.
Installation procedure
1. Turn off the main power of the MVE-8000A and
disconnect the AC power cord from the wall outlet.
2. Loosen the four screws (with drop-safe) and remove
the front door assembly in the direction of the arrow.
3. Remove the four screws (B3 x 5), and remove the
“plug-in board loose-proof assembly”.
B3 x 5
B3 x 5
Plug-in board
loose-proof assembly