Sharp XE-A212 - Manual (Page 14)

12
Now you are ready for sales registration.
Starting sales entries 7
While the cash register is pre-programmed so it can be used with minimal setup, it does provide you
with optional functions. Especially to use direct PLU keys effectively, you should program for
PLU/subdepartments. Before you start programming, please read through the sales operations section to
understand optional functions.
Decimal point position (tab) setting for domestic currency
By default, “2” is selected. When your country has a different tab setting, you must change the setting. Please
refer to "Other programming" of “Various Function Selection Programming 1” (Job code 61) on page 51.
Rounding system
When your country has a special rounding system, such as Australia, Switzerland, Norway, Sweden, Denmark
and South Africa, you must change the setting to suit your country. For the setting for Australia, Switzerland,
Norway and South Africa, please refer to “Other programming” of “Various Function Selection Programming 1”
(Job code 67) on page 53. For the setting for Sweden and Denmark, please refer to “Other programming” of
“Various Function Selection Programming 1” (Job code 69) on page 55.
VAT/tax
The cash register provides 6 kinds of VAT/tax. Select an appropriate VAT/tax system first, then set tax rates (up
to 4 rates) and assign taxable status to departments. By default, VAT 1 is assigned for all departments.
Department programming:
The cash register is pre-programmed for departments as follows:
Department: Allow open price entry in normal department, taxable status- taxable 1 for all departments.
PLU/subdepartment programming:
The cash register is preprogrammed for PLUs/subdepartments as follows:
PLU/subdepartment selection: PLU is selected for all PLU codes so that you only have to program unit prices
and associated departments for them (by default, unit price is set to 0 and associated department is set to
department 1). Function parameters including tax status depend on the status of associated department.
• For direct PLU keys, PLU codes 1 through 70 are assigned for PLU 1 through 70 keys respectively. In case
you use the PLU level shift keys, you can add number of direct PLU keys. For the function details, please refer
to “PLU level shift (for direct PLU key)” on page 17 and for the programming details, please refer to "Direct PLU
key programming" on page 37.
Programming other necessary items 6
A212_1 03.7.5 8:00 AM Page 12