Reading (x) and resetting (z) of sales totals, Pa a, Pl l – Sharp XE-A212 User Manual
Page 66: Ps s, Pg g
64
READING (X) AND RESETTING (Z)
OF SALES TOTALS
• Use the reading function (X) when you need to take a reading of sales information entered since the last reset.
You can take this reading any number of times. It does not affect the register’s memory.
• Use the resetting function (Z) when you need to clear the register’s memory. Resetting prints all sales
information and clears the entire memory except for the GT1 through GT3, Training GT, BAL, reset count, and
consecutive number.
X1 and Z1 reports: Daily sales reports
X2 and Z2 reports: Periodic (monthly) consolidation reports
When you take an X or Z report, turn the mode switch to the appropriate position referring to the column of
“Mode switch position” shown on the table below, and use the following corresponding key sequence.
Item
Mode switch position
Key operation
OPX/Z
X
--
--
A
key: Sales total
@
key: Amount of cash in drawer
Dept. code
: Department sales total
d
For dept. 1 to 6: Dept. key (
!
to
(
)
PLU report by
designated range
X1/Z1
--
X1, Z1
X1, Z1
X2/Z2
--
X2, Z2
--
Flash report:
(Only display)
To clear the
display, press the
l
key or turn the
mode switch to
another position.
Full sales report
P
A
A
Reading:
Resetting:
Resetting:
P
All PLUs
End
PLU code
Start
PLU code
p
@
Reading:
All PLUs
End
PLU code
Start
PLU code
p
@
--
--
X1, Z1
--
--
--
--
X, Z
Full clerk report
Hourly report
X1, Z1
X1, Z1
--
X1, Z1
--
--
--
Individual clerk
report
P
L
L
Reading:
Resetting:
P
L
L
Reading:
Resetting:
P
s
s
Reading:
Resetting:
P
G
G
Reading:
c
Reading:
Resetting:
P
c
Resetting:
Open GLU report
Open GLU report
by clerk
--
--
X1
Balance report
r
Reading:
(The report of the current clerk)
(The report of the current clerk)
Summary of Reading (X) and Resetting (Z) Reports
1
A212_4 FOR THE MANAGER 03.7.5 8:03 AM Page 64