Sanyo Vizzon HT27546 - Manual (Page 12)

12
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
USING THE REMOTE CONTROL
PRECAUTIONS
To ensure safe operation, please observe the following precautions:
Replace both batteries at the same time. Do not use a new battery with
a used battery.
Risk of explosion, if battery is replaced by an incorrect type.
Do not expose the Remote Control Unit to moisture or heat.
➉
12
13
14
11
➈
16
15
17
18
➇
➀
➁
➂
➃
➄
➅
➆
➠
Points toward
TV
REMOTE CONTROL KEYS
➀
Input Key—Press to change the input signal source
as follows: Analog RF
➡ Digital RF ➡ Video1 ➡ Video2
➡Component2 ➡ Analog RF.
➁
Number Keys—Two keys must be pressed to select
a direct channel.
Example: Press 0 then 6 to select
channel 6.
For Analog Cable channels above 100, press and
hold the 1 key until C1– – appears, then press the
other two numbers.
➂
Info Key—Press to display the Digital and Analog Full
Banner information (press again to remove the
display).
Digital Full Banner display—Contains a two-part
Channel Number (Major and Minor) and Tuner ID. If
available the following is also included: Audio Info,
Program Title, and V-Chip Program Rating.
Analog Full Banner display—Contains the Channel
Number (analog antenna/cable), Tuner ID, Station ID (if
available), Program Title (if available), and V-Chip
Program Rating.
Program Title Program Rating
Digital Channel
Major Minor
Audio Info
Tuner ID
Program Title Program Rating
Cable Channel
Station ID