Sony SX-M100 - Manual (Page 8)

8
Location and Function of Parts and Controls
0 EXT IN-1 MIC/LINE (external 1 microphone/
line signal input) connectors and MIC/LINE
switch
EXT IN-1 MIC/LINE connectors
Accept an external audio signal.
MIC connector (XLR type): Connect a rostrum
or conference hall microphone.
Note
When you use a connecting cable with an XLR
connector, pin No.1 and the case (metal part) of
which are connected, noise may be picked up.
LINE connector (phono jack): Connect to
external equipment such as audio equipment.
MIC/LINE switch
Selects the signal input to the EXT IN-1 connector.
MIC: Set the switch to this position when a
microphone is connected.
LINE: Set the switch to this position when an item
of audio equipment is connected.
! ¡LINE OUT (line output) connectors
(phono jacks)
Supply the signal from the chairman’s unit/
delegate’s unit, that from the rostrum or conference
hall microphone. There are two connectors. Use
these connectors when recording the output to a
tape recorder or when sending the line output to
the monitor system transmitter by means of an
infrared or induction-based system.
!™ TELEPHONE COUPLER connector (6-pin
multi-connector)
Connect to the SX-T100 telephone coupler (not
supplied).
!£ EXT IN-2 MIC/LINE (external 2 microphone/
line signal input) connectors and MIC/
LINE (microphone/line signal select)
switch
EXT IN-2 MIC/LINE connectors
Input an external audio signal.
MIC connector (phone jack): Connect a rostrum
or conference hall microphone.
LINE connector (phono jack): Connect to
external equipment such as audio equipment.
MIC/LINE switch
Selects the signal input to the EXT IN-2 connector.
MIC: Set the switch to this position when a
microphone is connected.
LINE: Set the switch to this position when an item
of audio equipment is connected.
!¢ DELEGATE’S/CHAIRMAN’S UNIT
connectors (20-pin multi-connectors)
Connect to the SX-C100A/SX-C150/SX-D100A/
SX-D150 Chairman’s Unit/Delegate’s Unit. The
same signal is output from four connectors. Up to
15 SX-C100A/D100A units can be connected to
each of the four connectors. Thus, up to 60 SX-
C100A/SX-C150/SX-D100A/SX-D150 units can
be connected.
!∞ y (signal ground) terminal
Ground if necessary.
!§AC IN (AC power input) connector
Connect the unit to an AC power source by means
of the supplied AC power cord.