Sanyo SCP-7300 - Manual (Page 13)

Turning Your Phone ON and OFF
Turning Your Phone ON
ᮣ To turn your phone on, press .
Once your phone is ON, it displays “Looking for service...”
which indicates that your phone is searching for a signal. When
your phone finds a signal, it automatically enters standby mode.
At this point, you are ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of
searching, a Power Save feature is automatically activated.
When a signal is found, your phone automatically returns to
standby mode.
In Power Save mode, your phone searches for a signal
periodically without your intervention. You can also initiate a
search for service by pressing any key (when your phone is
turned ON).
Tip: The Power Save feature helps to save your battery power when you
are in an area where there is no signal.
Turning Your Phone OFF
ᮣ Press for two seconds until you see the powering down
animation on the display screen.
Your screen remains blank while your phone is off (unless the
battery is charging).
5
7300 Bell_EN_3b.qxd 05.1.14 13:37 Page 5