Sanyo SCP-7300 - Manual (Page 34)

Adjusting the Phone’s Volume Settings
To adjust the ringer/key volume:
1. Press to access the main menu.
2. Highlight Settings and press .
3. Highlight Sounds and press .
4. Highlight Ringer/Key Vol. and press .
5. Select the menu you wish to change and press .
ᮣ Ringer Volume for adjusting Ringer tone volume.
ᮣ Start-up/Pw-off for adjusting Start-up/Power-off tone volume.
ᮣ Key Beep for adjusting Key Beep tone volume.
6. Adjust the volume level by using the navigation key up or
down and press .
ᮣ Vibrate to set the vibrate feature to on and the ringer volume to
off. (Only appears in Ringer Volume Setting.)
ᮣ Ringer Off to set the Voice Call ringer volume to off.
(Only appears in Ringer Volume Setting.)
ᮣ Silence All to set all the ringer volume to off. (Only appears in
Ringer Volume Setting.) See “Silence All” on page 28.
To adjust Earpiece volume:
1. Press to access the main menu.
2. Highlight Settings and press .
3. Highlight Sounds and press .
4. Highlight Receiver Vol. and press .
5. Select either Earpiece or Speaker and press .
ᮣ When you use speakerphone mode, select Speaker during
step 5 above.
6. Adjust the volume level by using the navigation key up or
down and press .
Tip: You can adjust the ringer volume in standby mode by using
Side Volume key, and adjust earpiece volume during a call by using
the navigation key up or down or Side Volume key.
26
7300 Bell_EN_3b.qxd 05.1.14 13:37 Page 26