Sanyo SCP-7300 - Manual (Page 14)

Using the Battery
Installing the Battery
Your phone comes with a Li-Ion battery. Follow these steps to
install it:
1. Place the battery into the space beneath the antenna with the
metal contacts at the bottom, facing downward.
2. Gently press down until it’s in place and the battery release
latch snaps.
Removing the Battery
To remove your battery, follow these easy steps:
1. Make sure the power is off so that you don’t lose any stored
numbers or messages.
2. Push the battery release latch up and hold the battery.
3. Then pull it up and out at a 45-degree angle.
6
7300 Bell_EN_3b.qxd 05.1.14 13:37 Page 6