Star Micronics Star SP200 Series - Manual (Page 10)

– 10 –
2 Cut off the front edge of the roll paper
perpendicularly.
3 Confirm that the power of the printer is turned
on.
4 While observing the direction of the roll paper,
insert the top end of the paper beneath the paper
guide as far as it will go. If the roll paper is installed,
the top end of the paper automatically comes out
from the paper exit. After 2cm of paper are fed
out, the paper is automatically cut off.
5 Move the paper roll holder in the direction of the
arrow, and insert the roll so that the holes in the
core align with the axes of the paper roll holder.
Release the paper roll holder to secure the paper.
6 If the paper roll core has not been properly
aligned with the paper roll holder, the cover
cannot to properly seated until the paper position
is corrected.
7 Press the FEED (paper feed) switch to feed the
paper approximately 10cm.
Loading the Paper (Auto Cutter Model)
1 Lift the cover up approx. 3cm. Hold the cover
tilted at this angle, then pull it toward you to
remove it.
Cover
FEED
switch
Roll paper
Core
Axis
Paper roll holder
Roll paper
Cover Positioning rib
Paper roll holder