Star Micronics Star SP200 Series - Manual (Page 4)

– 4 –
Unpacking
Choosing a place for the printer
Before actually unpacking the printer, you should take a few minutes to think about where
you plan to use it. Remember the following points when doing this.
✓ Choose a firm, level surface where the printer will not be exposed to vibration.
✓ The power outlet you plan to connect to for power should be nearby and unobstructed.
✓ Make sure that the printer is close enough to your host computer for you to connect the
two.
✓ Make sure that the printer is not exposed to direct sunlight.
✓ Make sure that the printer is well away from heaters and other sources of extreme heat.
✓ Make sure that the surrounding area is clean, dry, and free of dust.
✓ Make sure that the printer is connected to a reliable power outlet. It should not be on the
same electric circuit as copiers, refrigerators, or other appliances that cause power spikes.
✓ Make sure that the room where you are using the printer is not too humid.
✓ Printer
✓ User’s manual
✓ Ribbon cartridge
✓ Ferrite core
(EU only)
✓ Fastener
(EU only)
Printer
User’s manual
Ribbon Cartridge
Ferrite core (EU only)
Fastener (EU only)