Star Micronics Star SP200 Series - Manual (Page 6)

– 6 –
ON LINE POWER FEED
3 POWER lamp (Green LED)
4 ON LINE lamp (Green LED)
1 ON LINE switch
2 FEED switch
Control Panel
1 ON LINE switch
Switches the printer between ON LINE and OFF LINE.
ON LINE and OFF LINE switching is possible only
when paper is loaded in the printer.
2 FEED switch
• When this switch is pressed and then released within
0.5 sec., the paper feeds on line.
• When this switch is held depressed for more than 0.5
sec., the paper feeds continuously.
(The above paper feed operation is possible for both
ON LINE and OFF LINE modes.)
3 POWER lamp (green LED)
• Lights when the power to the printer is on.
• Flashes when paper is out, mechanical error occurs, when there is an alarm due to head
temperature detection, or when a CPU error has occurred.
• If the paper is out, load new paper and press the ON LINE switch.
• When the POWER lamp flashes due to occurrence of a mechanical error, turn off the power and
remove the cause of a mechanical error and then turn on the power again to reset the printer.
• If the POWER lamp flashes due to the alarm of the head temperature detection, the printer will
be set automatically when the head temperature becomes low.
4 ON LINE lamp (green LED)
LED lit: Printer is ON LINE
LED off: Printer is OFF LINE
LED flashes: CPU error
When the POWER lamp and ON LINE lamp light simultaneously, a CPU error has occurred.
Loading the Ribbon Cartridge (Tear Bar Model)
1 Turn off power to the printer.
2 Lift the cover up approx. 3 cm. Hold the cover
tilted at this angle, then pull it toward you to
remove it.
Cover
Power off