Star Micronics Star SP200 Series - Manual (Page 11)

– 11 –
9 Pull on the edge of the paper to remove any slack
and then lower the auto cutter.
0 Insert the paper through the paper outlet and then
replace the cover by reversing the removal steps.
Note: When the paper end mark appears on the
paper, replace the roll paper before it runs
out.
8 Insert the tip of the roll paper in the auto cutter
paper slit.
• When using copying paper, insert only the original
(the upper paper) into the slit of the auto cutter.
Insert the paper which is to be copied (the lower
paper) between the platen and the auto cutter.
Auto cutter
Paper
insertion
slit
Upper paper
FEED switch
Print head
Paper insertion
slit
Platen
Lower paper Print head Platen
Lower paper
Upper paper
Auto cutter
Paper outlet
Auto cutter
Paper insertion
slit