Sony Playstation 2 SCPH-90001 - Manual (Page 20)

20
, There may be a problem with the memory card in use. If you have another
memory card that is compatible with the PlayStation ® 2 console, try switching
memory cards.
Data saved on a memory card is corrupted.
, While saving, loading, copying or deleting data, do not attempt any of the
following. Doing so may cause the data to become corrupted.
• Do not remove the memory card or the controller.
• Do not open the disc cover.
• Do not reset the console.
• Do not turn off the console.
The console does not function properly.
, Static electricity and other similar occurrences may affect the console's
operation. Turn off the console and unplug it from the electrical outlet. Then plug
in the console and turn it on.
The ?/1 indicator flashes in red and the console does not work.
, Do not use the console until the flashing stops. Placing the console in an
extremely hot location or blocking the console's vents raises the internal
temperature of the console, thereby preventing proper operation.
You forgot your password.
, You can clear the password using the following procedure:
1 Insert a DVD without the parental control feature.
2 In the control panel, select x (Stop) to stop playback, and then
select x (Stop) again to clear resume play.
3 In the control panel, select (Setup) t "Custom Setup" t
"Parental Control" and then press the button.
The screen to enter a password is displayed.
4 Press the SELECT button on the controller, and then enter the
number "7444" on the screen that is displayed.
The registered password is cleared, and the screen for registering a new
password is displayed. Enter a new password.
The DVD does not function. Some DVD settings cannot be changed.
, The playback status or settings of some DVDs are preset intentionally by the
manufacturer. Because the PlayStation ® 2 console plays DVDs according to the
settings on the disc, some functions may not be available even if you follow the
procedures in this document and the User’s Guide (
page 8).
, Some settings cannot be changed during playback or resume play. Select
x (Stop) in the control panel to stop playback, and then select x (Stop) again to
clear resume play.
A connection to the network cannot be established.
, Check that the network settings are correct. Refer to the information from your
broadband Internet service provider and the instructions supplied with the
software in use and adjust the settings accordingly.
, Check that the Ethernet cable is properly connected.
, Check that you are using the correct type of Ethernet cable (cross cable or straight
cable). Refer to the instructions supplied with the network device for details.
, Check that the network device is properly connected. Also check that the settings
of the network device in use are correct. Refer to the instructions supplied with
the network device for details.
Network