Sony HTSS370 - Manual (Page 36)

36 GB
Enter the frequency of a station directly by
using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also press INPUT SELECTOR
+/– on the receiver.
2
Press D.TUNING.
3
Press and hold SHIFT, then
press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1
b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1
b 3 b 5 b 0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna
(aerial) for optimum reception.
4
Press and hold SHIFT, then
press ENTER.
If a wrong frequency is entered
“FM ---.--” or “AM ----” appears and then the
display returns to the current frequency.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
(Models of area code SP1, TW2,
TH1 only)
The AM tuning interval can be set to either
10 kHz or 9 kHz.
1
Press TUNER repeatedly until
“AM” appears on the display.
2
Press MENU/HOME.
3
Press V/v repeatedly until “AM
STEP” appears on the display,
then press
or b.
“10K t 9K” or “9K t 10K” appears on
the display.
4
Press .
“COMPLETE” appears on the display.
The AM tuning interval is changed.
5
Press MENU/HOME.
Note
If you change the interval, AM preset stations will
be erased.
Tuning into a station directly
(Direct Tuning) Changing the AM tuning interval