Symbol Technologies PTC-860IM - Manual (Page 23)

4. Plug the charger into the wall outlet. The green charging
indicator above the display lights.
5. Charge the PTC’s battery pack for 14 hours.
ᮣ
Checking the PTC-860
1. Press the ON/OFF key to turn on the PTC.
2. Look at the PTC’s display. What appears on the display
depends on the program your organization uses.
If the PTC is operating correctly, you should not see any of
the following:
• A low-battery warning
• A backup battery warning
• A blank display screen
Repeat the steps in this section if the PTC-860 is not
operating properly. You should not hear any beeps warning
you that an error has occurred. If you do hear warning
beeps, refer to the “Troubleshooting” section on
page 49 or
contact your Telxon service representative.
21