Sanyo PLC-XF60A - Manual (Page 27)

27
Basic Operation
Basic Oper
ation
Turn on the MAIN On/Off switch of the projector. The LAMP
indicator lights red, and the READY indicator lights green.
Press the POWER ON-OFF button on the top control or the
remote control. The LAMP indicator dims, and the cooling
fans start to operate. The preparation display appears on the
screen and count-down starts. The input and source
selected last appears after 20 seconds count-down.
2
3
1 Complete peripheral connections (with Computer, VCR, etc.)
before turning on the projector. (Refer to pages 22~24 for
connection.)
Turning On the Projector
What is PIN code?
PIN (Personal Identification Number) code is a security code that allows
the person who knows it to operate the projector. Setting a PIN code
prevents the projector from being operated by an unauthorized person.
A PIN code consists of a four-digit number. Refer to Security in Setting on
page 55 for locking operation of the projector with your PIN code.
Pointer (yellow frame)
After the OK icon
disappears, you can
operate the projector.
PJ PIN code Input Dialog Box
Enter a PJ PIN code
Select a number by using the Point buttons (e, d, 7, and 8) or
Control pad and fix the number with the SELECT button. The number will
change to “
✳”. If you fixed a wrong number, move the yellow frame
pointer to “C” or “Ent” once, then enter the correct number.
Repeat this step to complete entering a four-digit number.
When the four-digit number is fixed, move the yellow frame pointer to
“Ent”. Press the SELECT button so that you can start to operate the
projector.
If you entered a wrong PIN code, the entered number ( ✳✳✳✳) will turn red
and disappear. Enter a PIN code all over again.
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector can no
longer be started. Set a new PIN code with special
care, write it down in column on page 79 of this
manual, and keep it at hand. Should the PIN code be
missing or forgotten, consult your sales dealer or
the service station.
16
The preparation display disappears after 20 seconds.
(See pages 36~37 for Input)
Selected Input and Source
If the projector is locked with a PJ PIN code, PJ PIN code
Input Dialog Box will appear. Enter the PIN code as
instructed below.