Sanyo PLC-XF60A - Manual (Page 37)

37
Input
Input
Y, Pb/Cb, Pr/Cr
When the input source is component
coming from video equipment connected to
the Input 3 (Y, Pb/Cb, Pr/Cr) terminal, select
Y, Pb/Cb, Pr/Cr.
Input 3
Move a pointer to Input 3 and press the SELECT button.
Input 4/Input 5
When video input signal is connected to the
Input 3 (VIDEO) terminal, select Video.
Video
When video input signal is connected to the
Input 3 (S-VIDEO) terminal, select S-Video.
S-Video
When the input source is analog coming
from a computer through the Input 2 (5
BNC-type: Red, Green, Blue, H. Sync., and
V. Sync.) terminal, select RGB.
RGB
When video input signal is connected to the
Input 2 (VIDEO) terminal , select Video.
Video
Input 2
Move a pointer to Input 2 and press the SELECT button.
Y, Pb/Cb, Pr/Cr
When the input source is component
coming from video equipment connected to
the Input 2 (Y, Pb/Cb, Pr/Cr) terminal, select
Y, Pb/Cb, Pr/Cr.
Move the pointer to
RGB, Video, or Y, Pb/Cb,
Pr/Cr, and press the
SELECT button.
Source Select Menu
Move the pointer to
Video, Y, Pb/Cb, Pr/Cr,
or S-Video and press
the SELECT button.
Source Select Menu
✔
Note:
• Input 4 and Input 5 can not be selected when no interface
board is inserted into the respective slots. (p.21)
• Input 5 terminal can only accept digital signals.
• Adjusted values or selected settings in Input 4 and Input 5
return to factory default setting when the connected interface
boards are removed from those terminal slots.
A source menu appears corresponding to the board module
inserted into the Input 4 and Input 5 terminals.