Sanyo PLC-XF60A - Manual (Page 51)

51
Setting
PIN Code Change
Logo PIN code can be changed to your desired four-digit number.
Select “PIN code change” with the Point buttons (e, d, 7, and
8) or the Control pad and press the SELECT button. Set a new
Logo PIN code.
Be sure to note the new Logo PIN code and keep it at hand. If
you lost the number, you could no longer change the Logo PIN
code setting. For details on PIN code setting, refer to relevant
instructions of the PJ Lock function on page 55.
Background
Three background settings are available in this projector. Select
one of the followings when no input source is connected to the
projector or no input signal is coming from the connected
equipment:
Blue . . . . . .blue colored background
My logo . . .the image you captured
Black . . . . .black colored background
Lamp
Control
This feature allows you to change brightness of the screen.
Normal . .normal brightness
Auto . . . .brightness according with the input signal
Eco . . . .lower brightness reduces the lamp power
consumption and extends the lamp life.
Mode
This projector is equipped with two lamps. Mode setting allows
you to switch using one (1) lamp or two (2) lamps.
2-Lamp . . . .light both of the lamps inside the projector.
1-Lamp . . . .light one lamp only. Auto, Lamp 1, or Lamp 2 can be
altered.
PIN Code change Dialog Box
Pointer
Select PIN code change and
press the SELECT button.
The PIN code input dialog
box will appear.
Lamp Control
✔
Note:
• When neither of the two lamps is lighted, the projector will shutdown automatically.
• When either of the two lamps does not light up, the LAMP 1/2 REPLACE indicator
blinks orange and the projector will light the other automatically.
• After changing the lamp mode, it cannot be switched again for 90 seconds.
Setting
Lamp Mode
When selecting Auto in 1-Lamp
mode, the projector automatically
selects either lamp of which the
total Lamp time is shorter and
lights it up.
Remote control
Four (4) remote control channels and eight (8) remote control ID
are prepared for the projector to prevent radio frequency
interference from the other equipment and mutual interference
between projectors when using them at the same time.
For example, operating the projector in “CH-2 and ID-7,” both the
projector and the remote control must be switched to “CH-2 and
ID-7.”
To change CH and ID for the projector;
Select a Remote control CH and ID in this Setting menu.
To change CH and ID for the remote control;
While holding down the CH or ID button and press the SELECT
button. The Remote control CH or ID switches sequentially for
one pressing the SELECT button. Changing CH and ID should be
done separately. (See pages 16 and 17 for details.)
Remote control
When pressing the SELECT button at Remote control,
the remote control CH and ID menu appears. Select CH
and ID respectively.
The setting
selected.
Pointer