Sony STR-DA7100ES - Manual (Page 100)

100 GB
x SURROUND L xxx . x dB
(Surround speaker (L) level)
Initial setting: 0 dB
You can adjust the level from –20 dB to +10
dB in 0.5 dB steps.
x SURROUND R xxx . x dB
(Surround speaker (R) level)
Initial setting: 0 dB
You can adjust the level from –20 dB to +10
dB in 0.5 dB steps.
x SURR BACK xxx . x dB
(Surround back speaker level)*
Initial setting: 0 dB
You can adjust the level from –20 dB to +10
dB in 0.5 dB steps.
x SURR BACK L xxx . x dB
(Surround back (L) level)**
Initial setting: 0 dB
You can adjust the level from –20 dB to +10
dB in 0.5 dB steps.
x SURR BACK R xxx . x dB
(Surround back (R) level)**
Initial setting: 0 dB
You can adjust the level from –20 dB to +10
dB in 0.5 dB steps.
x SUB WOOFER xxx . x dB
Initial setting: 0 dB
You can adjust the level from –20 dB to +10
dB in 0.5 dB steps.
x MULTI CH SW xxx dB (Multi
channel sub woofer level)
Initial setting: 0 dB
Lets you increase the level of the MULTI
CHANNEL INPUT sub woofer channel by
+10 dB. This adjustment may be necessary
when connecting a DVD player to the MULTI
CHANNEL INPUT jacks. The sub woofer
level from DVD players is 10 dB lower than
that of Super Audio CD players.
*
Only when the surround back speakers are set to
“SINGLE” on the SPEAKER SET UP menu (page
49).
**
Only when the surround back speakers are set to
“DUAL” on the SPEAKER SET UP menu (page
49).
Note
When one of the following sound fields is selected,
no sound is output from the sub woofer if all the
speakers are set to “LARGE” on the SPEAKER SET
UP menu. However, the sound will be output from
the sub woofer if the digital input signal contains
L.F.E. signals, or if the front or surround speakers
are set to “SMALL.”
• D.CONCERT HALL A
• D.CONCERT HALL B
• CHURCH
• JAZZ CLUB
• LIVE CONCERT
• STADIUM
• SPORTS
Advanced LEVEL menu
parameters
Use the CUSTOMIZE menu and set “MENU
EXPAND” to “ON” to enable display and
setup as follows. The initial setting is marked
with an underscore.
x PHASE AUDIO (Phase audio)
• ON
Lets you output front 2 channel source sound
(instead of the test tone) sequentially from
adjacent speakers.
• OFF
Note
The HDMI sound is not output when you display the
receiver’s menu on the TV monitor.
x PHASE NOISE (Phase noise)
• ON
Lets you output the test tone sequentially from
adjacent speakers.
• OFF