Sanyo PLV-55WHD1 - Manual (Page 15)

15
USING COMPONENT JACKS TO CONNECT A DVD PLAYER
OR OTHER DIGITAL EQUIPMENT
The Component Video jacks will accept HDTV, EDTV, or
SDTV video content.
Switch off the LCD Projection TV and external equipment
before connecting cable. (Cable is not supplied.) Follow
these steps to easily connect your STB or DVD Player to
this LCD Projection TV.
1 Connect DVD Player or similar digital equipment’s
Component Video Out to the LCD Projection TV’s
Video (VIDEO2 or VIDEO3) jacks.
2 Connect DVD Player or similar digital equipment’s
Audio Out to the LCD Projection TV’s VIDEO2 or
VIDEO3 Audio jacks.
3 Press POWER to turn on the LCD Projection TV,
then turn on external equipment.
4 Press INPUT to select Video 2 or Video 3 to view
the DVD program.
S-VIDEO
VIDEO
R-AUDIO-L (MONO) Y–––––Pb–––––Pr
VIDEO
3
VIDEO
2
VIDEO
1
WOOFER
AUDIO
OUTPUT
Y–––––Pb–––––Pr R-AUDIO-L (MONO)
R-AUDIO-L (MONO)
R-AUDIO-L (MONO)
DVD PLAYER
(or similar digital device such
as a Satellite Receiver.)
COMPONENT
VIDEO CABLE
2
1
1
2
What you will need for connections:
Component Video Cable – 1
Audio Cable – 1
■ VIDEO2 and VIDEO3 jacks have identical functions.
Compatible video devices can be connected to either set of
jacks.
■ Press the INPUT key after connecting the cables, to select
the Video 2 or Video 3 input signal. There is NO need to
tune to a blank channel.
■ “No Signal” will appear on the screen when no signal is
detected.
PTV BACK
1
4 5 6
2 3
INPUT
POWER
REMOTE CONTROL
4 3
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must
run All Channel Search twice before you can
select the AV inputs.
AUDIO
CABLE
ANALOG AV CONNECTIONS