Sanyo PLV-55WHD1 - Manual (Page 30)

30
The surface of the cabinet can be damaged if not properly maintained. Many
common household aerosol sprays, cleaning agents, solvents, and polishes will
cause permanent damage to the fine surface.
1. Unplug the power cord before cleaning the LCD Projection TV.
2. Gently wipe the screen and cabinet with a dry soft cloth.
The screen is likely to be damaged if it is not maintained properly. Do not use
hard objects like a hard cloth or paper. Do not use solvents or abrasives.
Note: Never spray liquids on the screen because they can run down and drip onto the
chassis. This may cause component failure not covered under Warranty.
WARNING INDICATOR
The WARNING indicator shows the state of the function which protects the LCD
Projection TV. Check the state of the WARNING indicator and the POWER
indicator to take proper maintenance.
The LCD Projection TV is shut down and the WARNING indicator is flashing red
When the temperature inside the LCD Projection TV exceeds the normal
temperature, it is automatically shut down to protect the LCD Projection TV. The
POWER indicator flashes red while the LCD Projection TV is being cooled down.
When the temperature inside the LCD Projection TV returns to normal, the
POWER indicator is turned off and then it can be turned on.
Note: The WARNING indicator continues to flash even after the temperature inside the
LCD Projection TV returns to normal. When the LCD Projection TV is turned on again, the
WARNING indicator stops flashing.
Then check the item below:
✓ Did you provide appropriate space for the LCD Projection TV to be ventilated? Check the
installation condition to see if ventilation slots are not blocked.
✓ Has the LCD Projection TV been installed near an Ar-Conditioning/Heating Duct or Vent?
Move the installation of the LCD Projection TV away from the duct or vent.
AMP
PLACE
WARNING
FRONT PANEL
WARNING
flashing red
The LCD Projection TV is shut down and the WARNING indicator lights red
When the LCD Projection TV detects an abnormal condition, it is automatically
shut down to protect the LCD Projection TV and the WARNING indicator lights
red. In this case, unplug the AC power cord and plug it, and then turn the LCD
Projection TV on once again to verify operation. If the LCD Projection TV is turned
off again and the WARNING indicator lights red, unplug the AC power cord and
contact Sanyo Fisher customer service.
CAUTIONS
DO NOT LEAVE THE LCD PROJECTION TV WITH
THE AC POWER CORD CONNECTED UNDER THE
ABNORMAL CONDITION. IT MAY RESULT IN FIRE
OR ELECTRIC SHOCK.
LAMP
PLACE
WARNING WARNING
FRONT PANEL
WARNING
lights red
CLEANING THE LCD PROJECTION TV
MAINTENANCE AND CLEANING