5) alarm setup, English-5-7 – Samsung SMO-210DN User Manual
Page 55
English-5-7
1. DWELL TIME SETUP
- Pressing SEQUENCE button in Single Screen will bring up the SEQUENCE MODE. You may set
the time display for each channel. If you set zero (0) seconds as the DWELL TIME for a particular
channel, the set channel will be skipped and next channel will be shown. You may
set time in the QUAD-A, QUAD-B screens.
[0SEC, 1SEC, 2SEC, 3SEC.................... ~ 60SEC]
- Use
,
,
¥
,
, key to make changes.
5-5) ALARM SETUP
•
Function: Allows users to set the ALARM MODE for each camera.
•
Setting method: Move to #6. ALARM MENU by using
KEY in the SETUP MENU, and
press the ENTER SWITCH to display the OSD as shown in the figure below. (The figure shows
the initial setting status.)
(1) CAM1 to CAM8 item sets whether the alarm sensor connected to the camera is used or not.
(ON: Alarm function setting, OFF: Alarm function canceling)
(2) HOLD TIME item sets time to freeze alarm operation when alarm occurs.
(HOLD TIME to be set: 05SEC ~ 1MIN ~ 30MIN)
* Note : If you want to carry alarm operation, you must pre-set ALARM ON/OFF TIME item in
monitor before CAMERA ALARM is set to ON. If you do not pre-set ALARM ON/OFF
TIME item in advance, alarm operation is not carried though CAMERA ALARM is set to ON.
(3) ALARM TONE sets whether or not alarm tone (high-pitched tone)sounds when an ALARM or
VIDEO LOSS occurs.
(ON: ALARM TONE operation, OFF: Cancel)
05/01/05
00:00:01
CAM1
ON
CAM2
ON
CAM3
ON
CAM4
ON
CAM5
ON
CAM6
ON
CAM7
ON
CAM8
ON
HOLD TIME
05SEC
ALARM ON TIME
00:00
ALARM OFF TIME
00:00
ALARM TONE
ON
ALARM
SETTING