6) alarm record mode, English-5-8 – Samsung SMO-210DN User Manual
Page 56
5-6) ALARM RECORD MODE
The initial setup status of ALARM/MOTION RECORD SETUP menu is shown below.
1. ALARM RECORD ENABLE
If you want to start recording when Alarm rings, then select ON. If you do not want to start recording
when Alarm rings, then select OFF. If you set ALARM RECORD ENABLE to ON and exit the
menu, system starts recording whenever Alarm is activated.
The following screen shows that ALARM recording is in progress when ALARM is activated.
It showsIt shows the ALARM for Channel 4 is activated with an “A” mark.
[ON/OFF]
2. MAIN ALARM TIME
- Set the time to record video and audio when motion is detected or alarm is activated.
[OFF ,10SEC ,20SEC ,30SEC ,1MIN ,2MIN ,3MIN ,4MIN ,5MIN ,AUTO]
- Use
,
,
¥
,
, key to make changes.
3. PRE ALARM TIME LIMIT
- PRE ALARM recording is a feature that recognizes what kind of conditions were present
immediately before motion was detected.
PRE ALARM TIME LIMIT can be set to record 1-5 seconds of video/audio right before motion
detection or an ALARM occurrence. The System memory always saves up to 5 seconds of video
and audio data. When motion is detected or an ALARM occurs, ALARM recording starts and
PRE-ALARM data is simultaneously recorded from the System memory to HDD up to the time
length set in PRE ALARM TIME LIMIT.
[OFF ,1SEC, 2SEC, 3SEC, 4SEC, 5SEC]
- Use
,
,
¥
,
, key to make changes.
05/01/05
00 : 00 : 01
CAM7
CAM8
A
CAM4
CAM5
CAM6
CAM1
CAM2
CAM3
English-5-8
05/01/05 00:00:01
ALARM RECORD ENABLE OFF
MAIN ALARM TIME
10 SEC
PRE ALARM TIME LIMIT
1 SEC
POST ALARM TIME LIMIT
OFF
MOTION DETECTION
OFF
SENSITIVITY NORMAL
MOTION CH SETUP...
ALARM/MOTION RECORD SETUP