Sony DSR-2000 - Manual (Page 125)

Chapter 7
Connections and
Settings
Chapter 7 Connections and Settings
125
Chapter
7
Connections and
Settings
Reference Video Signals for Analog Signal Editing
In order to provide stable video and audio signals for
analog editing, it is necessary to input a reference
video signal synchronized with the video signal to the
REF. VIDEO IN connector and set the REF. VIDEO
IN 75
Ω
termination switch to ON.
Connections for Cut Editing Using i.LINK Interface
(Optional DSBK-190 Required)
Using two DSR-2000/2000P units, each fitted with the
optional DSBK-190 board, as a pair of player and
recorder, you can configure a cut editing system.
You can use the same system also to digitally dub
signals in DVCAM format through an i.LINK interface
(see page 61).
REF. VIDEO IN connector
and 75
Ω
termination switch
It is also possible to use an i.LINK-compatible
camcorder such as the DSR-500WS/500WSP as the
player and carry out cut editing.