Sony DSR-2000 - Manual (Page 133)

Chapter 7
Connections and
Settings
Chapter 7 Connections and Settings
133
Connections for Digitally Dubbing Signals in
DVCAM Format
(Optional DSBK-190 Required When
Using i.LINK Interface)
You can use this unit to digitally dub signals in
DVCAM format automatically from the beginning of
the tape to the end, through an i.LINK or SDTI(QSDI)
interface.
For information about how to carry out digital dubbing, see
the section “Digitally Dubbing Signals in DVCAM Format”
(page 61).
Connecting two DSR-2000/2000P units using
the i.LINK interface (DSBK-190 i.LINK/DV
Input/Output Board)
Make the same connections and settings as described
in the section “Connections for Cut Editing Using
i.LINK Interface” (page 125).
DSR-2000/2000P (player) settings
Control Setting
REMOTE button Lit
9PIN button Lit
DSR-2000/2000P (recorder) settings
Control Setting
REMOTE button Unlit
9PIN button Lit
SDTI/i.LINK button SDTI
(input selection section)
SDTI(QSDI) OUTPUT SDTI(QSDI) INPUT
REMOTE-IN REMOTE-OUT
1
2
DSR-2000/2000P (player)
1 75
Ω
coaxial cable (not supplied)
2 RCC-5G 9-pin remote control cable (supplied)
DSR-2000/2000P (recorder)
Connecting two DSR-2000/2000P units using the SDTI(QSDI) interface
When connecting this unit with a DSR-60/60P/
80/80P/85/85P/90/90P unit using the
SDTI(QSDI) interface
Replace the DSR-2000/2000P (player) shown in the
above diagram with a DSR-60/60P/80/80P/85/85P/90/
90P unit and make the same connections as shown
above.
The SDTI(QSDI) interface connector of the DSR-60/
60P/80/80P/85/85P is marked “QSDI(OUTPUT)”.