SMC Networks Barricade SMC2404WBR - Manual (Page 115)

it to the location of the firmware file. Click the "Apply" button and follow
the prompts. You will notice the lights on the Barricade will react in a
certain sequence. Wait patiently while the Barricade performs its reboot
sequence.
5. Your 2404WBR has now been successfully upgraded. Please log into the Barricade's management
and configure the router according to your type of broadband connection.
Q. How do I configure the Barricade using a MacIntosh?
A. Please follow the steps as they are outlined below:
1. Click on the <Apple> key, choose Control Panels, and select TCP/IP
2. Select "Connect via Ethernet Built In or Ethernet Slot"
3. Set the next option to "Configure using <DHCP>"
4. Hit the close box in the top left corner you will be asked to save. Hit
<Save>
5.
Optional: Select Edit, User Mode, and Advanced. Click on the
"Options…." Button to verify that TCP/IP is active.
Q. Can I assign static IP addresses to machines behind the router? If so,
how?
A. Yes. Note that each machine MUST have a different IP address and
DNS host name. You can also enter your ISP’s DNS numbers instead of the
router’s IP address if you wish to do so. See below:
Windows 9x/ME
1) Go to your control panel and double-click on Network.
2) Double-click where you see TCP/IP (ethernet card).
3) Click specify an IP address and type in 192.168.2.55
4) Where it says subnet mask, type in 255.255.255.0
5) Click on the gateway tab and type in 192.168.2.1. Click add
6) Click on the DNS tab and enable it. Set the host name to 123 and the DNS
Search Order to 192.168.2.1. Then click OK twice.
7) Restart the computer when it requests you too.
Windows 2k/XP
1) Go to your control panel and double-click on Network and Dialup