Sennheiser evolution wireless serie ew500 - Manual (Page 87)

84
Recommendations and tips
... for the ME 2 and ME 4 clip-on microphones
ț To reduce level variations to a minimum when the user turns his or her
head away from the microphone, attach the microphone as centrally as
possible.
ț To protect the microphone against excessive sweat/moisture, avoid direct
skin contact.
ț Attach the microphone carefully and conduct the cable such that noise
due to friction is avoided.
ț
Always use the ME 4 directional microphone with a windshield and direct
the microphone towards the sound source (e.g. mouth).
... for the ME 3 headmic
ț Always use the microphone with a popshield and position the microphone
at the corner of the mouth.
ț
You can vary the bass reproduction by increasing/decreasing the talking
distance.
ț
Make sure that the sound inlet is directed towards the mouth. The sound
inlet is marked with a little dot.
... for the SK 500 pocket transmitter
ț
Make sure that the antenna and the microphone cable do not cross.
ț
The antenna should hang freely and be at least 1 cm away from the
body. The antenna must not be in direct contact with the skin.
ț
For best results, make sure that the transmitter sensitivity is correctly
adjusted.
... for the SKM 500 hand-held transmitter
ț Hold the SKM 500 hand-held transmitter in the middle of the microphone
body. Holding it close to the sound inlet basket will influence the
microphone’s pick-up pattern, holding it at the lower part of the body
will reduce the transmitter’s range.
ț
You can vary the bass reproduction by increasing/decreasing the talking
distance.
ț
For best results, make sure that the transmitter sensitivity is correctly
adjusted.