Sharp AJ-2200 - Manual (Page 15)

13
SET
TING UP THE PRINTER
INDICATOR LIGHTS
When only the green power lamp is lit, the printer is working properly.
When a printer error occurs, a light will indicate what problem has occurred, as explained
below.
When turning on the unit for the first time after purchasing, the ink lamp blinks
rapidly because print heads and ink tanks are not attached yet. The lamp will go
out when the initial setup completes.
......lit ......blinking ......fast blinking ......extinguished (lamp is off)
Light condition
Problem and Solution
Paper tray is empty, or a paper jam has occurred.
Load more paper or remove the jammed paper and press the
paper button.
No ink, or a print head is not installed.
Change the ink tank, or install a print head.
Front cover is open.
Close the front cover.
The printer is warming up, or receiving data.
Please wait.
Power Paper Ink
For more details on solving a problem, refer to the "Troubleshooting" section of the Online Manual.
The carriage is not operating normally, or some errors
may have occurred inside the printer.
If any paper is jammed, remove the jammed paper, and then
press the "Paper" button. If no paper is jammed, press the
"Paper" button to cancel the error warning. If the lights are
still blinking even after trying to cancel the error, disconnect
the power plug from the printer, and then insert it again.
If your printer still does not work, please contact your
authorised SHARP service centre.