Sharp AJ-2200 - Manual (Page 25)

23
SETTI
NG
UP
FO
R
Wi
ndow
s
SETTING UP FOR Windows
To use this printer with your computer, the printer driver should be installed onto your
computer's hard drive. In this chapter, you will learn how to install them and how to use the
Online Manual.
The following term is used in this chapter.
CD-ROM
Means the supplied CD-ROM with the AJ-2200 software.
HARDWARE AND SOFTWARE REQUIREMENTS
Check the following hardware and software requirements in order to install the AJ-2200
printer driver.
*
1
Compatible with Windows Me, Windows 98 or Windows 2000 preinstalled model with
USB interface equipped as standard.
*
2
Printing is unavailable in MS-DOS mode.
BEFORE INSTALLATION
The method to install the printer driver varies depending on your operating system and the
cable connecting the printer and your computer. Check your interface and operating
system, and then follow the steps shown below to install the printer driver.
Computer type IBM PC/AT or compatible computer equipped with a
USB*
1
or bi-directional parallel interface (IEEE1284)
Operating system*
2
Windows Me, Windows 98, Windows 95, Windows 2000,
Windows NT 4.0 (Service Pack 3 or later)
Display 640 x 480dots (VGA) or better
Hard disk free space 10MB or more
Other requirement for hardware An environment on which any of the operating systems
listed above can fully operate
Windows Me
Windows 98
Windows 2000 *
Windows Me
Windows 98
Windows 95
Windows NT 4.0 *
Windows 2000 *
USB
Parallel
"Installing onto Windows Me (USB interface)" (page 24)
"Installing onto Windows 98 (USB interface)" (page 27)
"Installing onto Windows 2000" (page 31)
"Installing onto Windows Me/98/95/NT4.0 (Parallel interface)"
(page 34)
"Installing onto Windows 2000" (page 31)
Operating system Interface Reference pages for how to install
* The administrator's authorisation is required to install a printer driver.