Sherwood R-863 - Manual (Page 12)

12
ENGLISH
LOADING BATTERIES
OPERATING COMPONENTS WITH REMOTE CONTROL
1 2
DVD
VOL. CH LEVEL
OSD CH SEL
INTRO
RETURN
DSP MODE
AUTO
ST CENTER MODE TEST TONE DISC P.SCAN
TUNER CD T1/MON AUX PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISP SLEEP DIRECT IN ROOM2
RPT A B
7.1 SURR TITLE
ENTER
HOME THEATER MASTER RNC-220
CHANNEL SELECTOR
ON/OFF
PHONES SPEAKER
TUNING/PRESET
VIDEO LABEL
ROOM2 FEED
AUDIO/VIDEO SURROUND RECEIVER R-863
MULTI CONTROL
DYNAMIC RANGE
T/P MODE
MASTER VOLUME
ON/STANDBY
STANDBY POWER
BAND CINEMA EQ
MEMO/ENTER
ON / OFF
S-VIDEO OPTICAL IN VIDEO L - AUDIO - R
WIDE RANGE AMPLIFIER STAGE W R A S
INPUT SELECTOR AUDIO VIDEO DIGITAL/ANALOG EXTRA SURR.
6.1/7.1
STEREO TAPE MON. 7.1CH DIRECT DECODING SURROUND MODE
LOCK LOCK
7m
30 30
MULTI ROOM
REMOTE SENSOR
SOURCE
DIRECT
TONE MODE TEST TONE
REMOTE CONTROL OPERATION RANGE
• Use the remote control within a range of about 7
meters (23 feet) and angles of up to 30 degrees
aiming at the remote sensor.
Remove the cover. Load four batteries(“AAA” size, 1.5 V)
matching the polarity.
When this remote control does not operate the component, the old batteries should be replaced.
If the batteries are removed for a longer period of time, the remote control might lose its memory and require
reprogramming
• When a button is pressed, the corresponding DEVICE
button flickers.
• When operating a Sherwood CD player or tape deck
using the system remote control, aim the remote
control at the REMOTE SENSOR on this unit.
• However, in case of Sherwood DVD player, aim it
at the REMOTE SENSOR on the corresponding
component.
Enter the setup code of the components
respectively, referring to “ENTERING A
SETUP CODE”(page14).
Turn on the components you want to
operate.
1
Press the DEVICE button on the remote
control corresponding to the component
you want to operate.
2
Press the button corresponding to the
operation you want while aiming the
remote control at the REMOTE SENSOR
on the component.
3
4