Schumacher Automatic Battery Charger / Maintainer SC-200A - Manual (Page 11)

• 11 •
50 Amp Battery Clips
Connect the end of the charger output cable to the end of the 1.
50 Amp Battery clips cable.
Follow the steps in sections 6 and 7 to connect the output clips 2.
to the battery.
After a good electrical connection is made to the battery, plug 3.
the power cord into a 120V AC electrical wall outlet. Make sure
to place the charger on a dry, non-flammable surface, like metal
or concrete.
Permanent Ring Connectors
The ring connectors permanently attach to the battery providing easy
access to quickly charge your battery. This application is appropriate
for motorcycles, lawn tractors, ATVs and snowmobiles.
To permanently attach to a battery, loosen and remove each nut 1.
from the bolt at the battery terminal.
Connect the red POSITIVE connector ring to the POSITIVE 2.
battery terminal.
Connect the black NEGATIVE connector ring to the NEGATIVE 3.
battery terminal.
Replace and tighten the nuts to secure. 4.
Connect the cable to the end of the charger output cord. 5.
Take care to keep the wires and plug away from metal and
moving parts.
Plug the charger power cord into a 120V AC electrical wall 6.
outlet. Make sure to place the charger on a dry, non-flammable
surface like metal or concrete.
12V Accessory Plug
Charge or maintain your battery without lifting the hood.
Connect the end of the 12V Accessory Plug Cable Quick- 1.
Connect to the charger.
Insert the 12V accessory plug into the 12V accessory outlet. 2.
Route the power cord from the charger through the vehicle’s 3.
open window.
Plug the charger power cord into a 120V AC electrical wall 4.
outlet. Make sure to place the charger on a dry, non-flammable
surface like metal or concrete.