Sanyo DP52848 - Manual (Page 5)

5 Need help? Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
Wall Mounting
Inserts
INSTALLATION GETTING STARTED
2 Antenna Connection for off-air signals.
THE TUNER IN THIS HDTV CAN RECEIVE :
a. Digital and Analog off-air signals from an
antenna.
OR
b. Analog or ClearQAM cable channels from a
direct Cable TV connection.
NOTES: You must use the on-screen MENU to
Search for ClearQAM Cable channels. See
page 11.
For the best picture, connect your Cable box
or Satellite receiver to HDMI1, 2, 3, or com-
ponent jacks (Video2 or 3).
This HDTV can receive ANY unscrambled RF
signal being broadcast.
ANTENNA
CABLE
OR
ANALOG / DIGITAL
ANTENNA IN
Mounting screws measurements:
M6 Diameter, Length—14mm (min.); 16mm (max.)
DETACHING THE TV STAND
Tools Needed: Phillips screwdriver
Important Note: Place HDTV face down on a
padded or cushioned surface to protect the
screen and finish.
1 Remove the six (6) screws securing the foot
stand
. CAUTION: Hold the stand firmly as
you remove the last screw (save the screws
for wall mounting).
2 Carefully remove the HDTV stand.
WALL MOUNTING (OPTIONAL)
Use the screws you removed when dettaching the
stand to secure the HDTV to a wall mounting kit.
NOTE: Wall Mounting kit is not supplied.
VESA standard interface:
400 x 400
1 Install supplied batteries in the Remote.
(2 ”AAA”
eneloop
Ni-MH rechargeable batteries)
P RECAUTIONS
Do not use rechargeables together with
dry cells, other types, mixed new and old,
or batteries with different charge levels.
Do not expose the Remote or batteries
to moisture or heat.
Match the “+” and “–” signs on the batteries with marks
inside the Remote Control.
For eneloop battery recharging, please refer to your
battery charger’s instructions (battery charger not included).
Please recycle used up rechargeable batteries.
For more information visit : www.eneloopusa.com