Sanyo DP52848 - Manual (Page 9)

9 Need help? Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
INITIAL CHANNEL SEARCH
7 Press the CHANNEL
▲ (Up) key to search
for signals connected to the Antenna
terminal.
Channel Search will check for Antenna and
Cable signals. If Antenna signals are detected,
the HDTV searches for both analog and digital
off-air channels. If Cable signals are detected,
the HDTV will search for analog Cable channels.
Channels are stored in Channel Memory and
can be scanned using the CHANNEL
▲ (Up)
and
▼ (Down) keys.
If no Antenna signals are detected, the HDTV
will begin an AV search.
If neither of these searches detected a valid
signal, the HDTV will tune to input Video1.
INITIAL DISPLAY
AV SEARCH
NOTE: Be sure all the external video devices you con-
nected to the HDTV are powered ON before
you begin an AV Search.
8 Press the CHANNEL
▼ (Down) key to
search for signals from devices you con-
nected to the AV input jacks (Initial Display).
AV Search will begin checking the AV inputs for
valid signals, beginning with input Video1.
When a valid signal is detected, the search
process ends and the HDTV tunes to that input
source.
If a valid signal is not detected on any of the AV
inputs, the HDTV will tune to input Video1.
CHANNEL SEARCH DISPLAY
AV SIGNAL SEARCH DISPLAY
GETTING STARTED—POWER CONNECTION / CHANNEL SEARCH
POWER CONNECTION
5 Plug in AC power cord
(120V AC, 60 Hz).
6 Press the POWER key.
(Follow the on-screen
instructions.)
To 120V AC outlet.