Using autodial delay – Siemens HIPATH 8000 User Manual
Page 120
Step by Step
Enhanced phone functions
120
Using autodial delay
A number is automatically dialed after a set delay start-
ing from the entry of the number’s last digit. The auto-
dial delay can be used:
•
when dialing in idle mode
•
when deflecting an incoming call
•
Consultation
•
when transferring an answered call.
The delay can be reduced by performing one of the fol-
lowing activities:
•
pressing the
i
key. This always works.
•
lifting the handset. This only works if the phone
number was entered when the phone was idle or if
it was entered for a consultation call when the hand-
set was off hook.
•
pressing the loudspeaker key. This only works if the
phone number was entered when the phone was
idle and the loudspeaker key was not lit or if the
phone number was entered for a consultation call
and the loudspeaker key was not lit.
Settings for autodial delay
z You can also configure this setting via the Web interface
If you select
Autodial delay, you must either confirm
the "Dial" option, press the loudspeaker key or wait until
the autodial delay expires to set up a call when dialing
with the handset on hook.
v
Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec.
j
Enter and confirm the user password.
Select and confirm the option shown.
If an emergency number is preset by your admin-
istrator, the autodial delay for this phone number
is reduced to one second.
The setting does not affect automatic emergency
number dialing.
User
Configuration