Sony VGP-MR100 - Manual (Page 38)

38
Turn power on
Turn on the computer, the TV set, and the Network Media Receiver, and bring up the video output
from the Network Media Receiver on the TV screen.
To use the Network Media Receiver, the computer must be started up, the TV set must be switched
on, and the TV must be set to the input to which the Network Media Receiver is connected.
1
If the Network Media Receiver is connected to a hub or a router with
built-in hub, turn on the hub or router.
2
Turn on the computer.
3
Press the TV POWER button on the remote control to turn on the TV
set.
4
Use the TV/VIDEO button on the remote control to select the input to
which the Network Media Receiver is connected.
5
Press the Network Media Receiver POWER button on the remote
control to turn on the Network Media Receiver.
The standby indicator changes to green, and the “Select a server...” screen appears
on the TV.
“Select a server...” screen
Select a server•••
SELECT :Select :System Settings OPTIONS
ServerA-VAIO Media-
Server other than DLNA
ServerB
ServerC
ServerD
1/5
For details on using the “Select a server...” screen, see page 39.
z Hint
You can start the server computer automatically when the Network Media Receiver is turned on by
configuring the settings described in “Having the computer start up automatically” on page 52.
Note
For about 20 seconds after the power cord is connected, the Network Media Receiver cannot be turned on.
Verify that the standby indicator is lit red before pressing the Network Media Receiver POWER button.