Star Micronics NP-225 - Manual (Page 34)

31
33) Download bit image definition :<< GS * n1 n2 Dn >>
Code : < 1D >h + < 2A >h + n1 + n2 + Dn * < 0 ≤n1≤FF >h
* < 00 ≤n2≤30 >h
* < n1 x n2 ≤51F >h
Description : Defines “download bit image” of number of dots specified by n1 and n2.
* Horizontal dot numbers are obtained by n1 x 8 and vertical dot numbers by n2 x 8.
* Dn is bit image data.
* Once “download bit image” is defined, it is valid until it’s redefined, download
character is defined, external characters are specified, software is reset, power is set
off or INIT signal is input.
* “Download bit image” cannot be defined at the same time with “download
characters” or “external characters”. If this command is executed, “download
character definition” or “external characters contents” are cleared.
* The relationship between bit image data & defined dots is shown below.
n1x8dots
d1 MSB
dn2+1
dn2x2+1
d2
dn2+2
dn2x2+2
n2x8dots
LSB
dn2 dn1xn2x8
dn2x2
34) Download bit image print :<< GS / m >>
Code : < 1D >h + < 2F >h + m * < 00 ≤m≤03 >h
Description : Prints “download bit image” in a mode assigned by “m”.
* Modes to be assigned by m are as follows.
Dot density
m Modes
Vertical Horizontal
00 Normal mode 203 dpi 203 dpi
01 Double width 203 dpi 101 dpi
02 Vertical double 101 dpi 203 dpi
03 Quadruple 101 dpi 101 dpi
* If there are some data left in the print buffer, this command is neglected.
* If “download bit image” is not defined yet, this command is neglected.
* “Download bit image” data exceeding 1 line cannot be printed.
* “Download bit image” cannot be defined at the same time with “download character” or
“external characters”