Star Micronics NP-225 - Manual (Page 6)

3
CODABAR (NW-7) Е Е
CODE128 Е Е
2-D symology QR code Е Е
Parallel Centronics Е Е 5 Interface
Serial RS-232C Е Е
6 Auto-cutter 1. Cut method Guillotine type Е Е
2. Applicable paper Thermal 65 - 125
(micro)
Е Е
3. Cut cycle 30 cuts / minute
Е Е
4. Cut mode (by command
setting) Total cut
Partial cut (a 2mm tab
left at the center)
Е Е
5. Life time 300,000 cuts
Е Е
1. Paper width 60 mm 80 mm 112mm
2. Max. diameter Ø80 mm / Ø83 mm Ø83 mm Ø83 mm
3. Core diameter Inner Ø12mm
Outer Ø18mm
7 Paper
specs.
4. Papers recommended TF50KS-E2D (Nihon Seishi)
PD160R-N (Shin Oji Seishi)
AFP235 (Mitsubishi Seishi)
TL69KS-R2 (Nihon Seishi)
TL69KS-HW74 (Nihon Seishi)
TC98KS-T1 (Nihon Seishi)
8 Receiving
buffer
Approx. 10K bytes
9 Operation
SW
ALMLED OUT
Line feed SW input
10 Weight Net weight approx. 550g / 650g approx. 750g approx. 1,250g
11 Low sensor Approx. 22.5 Ø (approx.2.5m+-1m. When inner
of paper core is Ø 12 and outer is Ø 18)
Reflection sensor. Approx. 3m +- 1.5m
(When inner of paper
core is Ø 12 and outer
is Ø 18.) Changeable
reflection sensor