Star Micronics NP-225 - Manual (Page 36)

33
Code : < 1B >h + < 61 >h + n * < 00 ≤n≤02 >h
Description : Aligns all data to be printed on the assigned position in a line.
* “n” values are assigned to:
n (Hex) Position
00 Left
01 Center
02 Right
* This command is valid only when it is input at the head of a line.
* The default value of “n” is [00]h.
39) Total cut (Full cut)
:<< ESC i >>
* The command functions differently between Standard and Windows models.
Code
: < 1B >h + < 69 >h
[Standard]
* Full-cut the paper.
* Effective at the head of a line
* Feeds paper by 3mm after paper cut to prevent from paper jam.
[Windows]
* Full-cut the paper after feeding by 21.25mm
* Effective at the head of a line
* Feeds paper by 3mm after paper cut to prevent from paper jam
40) Partial cut :<< ESC m >>
* The command functions differently between Standard and Windows models.
Code
: < 1B >h + < 6D >h
[Standard]
* Partially cut paper (with one point left uncut at the center position)
* Effective at the head of a line
* Feeds paper by 3mm after paper cut to prevent from paper jam.
[Windows]
* Partially cut paper (with one point left uncut at the center) after feeding paper by
21.25mm.
* Effective at the head of a line.
* Feeds paper by 3mm after paper cut to prevent paper jam.
41) No paper sensor select :<<ESC c 3 n1 n2>>
Black mark sensor command
Code :<1B>h + <63>h + <33>h + n1 + n2 * < 00 ≤n1≤01 >h
* < 00 ≤n2≤FF >h
* n1 = 0, no paper sensor (thermal paper)
* n1 = 1, black mark sensor (label paper)
* Value “n2” is available only at label selection in “n1”.
Feeds paper by dots assigned after label position is confirmed.
Minimum amount of paper feed: 0.125mm
Feeds 0.125mm x “n2” amount of paper
Default value selects the thermal paper.
Auto loading function is not available at label selection.