Sanyo KHS0951 - Manual (Page 11)

11
OI-351-11EG
Using the Remote Control Unit (continued)
Mounting the Remote
Control Unit
When attaching to wall 1) Confirm the indoor unit beeps when the ON/OFF button is pressed at
the wall location where the remote control unit is to be attached, then attach
the holder to the wall.
2) When taking out the remote control unit, pull it from the holder.
When using the remote • Point the transmitter on the remote control unit at the sensor on the
control unit indoor unit when operating the remote control unit and the air conditioner.
• Do not place objects which may block the transmitted signals between
the receiver and the remote control unit.
Securing the remote 1) Attach the holder to the wall with one screw in the upper hole only.
control unit to prevent theft
2) Remove the cover from the remote control unit, and then remove the
batteries. Next, place the remote control unit in the holder.
3) Secure both the remote control unit and the holder to the wall with another
screw through the lower hole.
4) Put the batteries back in the remote control unit, and then replace the
cover.
Press
Hook
Remote
control
unit holder
Remote
control
unit holder
Holder
Truss-head
tapping screws
5/32 x 5/8 “ (4 x 16 mm)
(supplied)
Truss-head
tapping screws
5/32 x 5/8 “ (4 x 16 mm)
(supplied)