Sharp ER-A520 - Manual (Page 132)

130
Link PLU/UPC link
PLU/UPC codes must have already been defined.
You can program a maximum of 15 link PLUs/UPCs. A link PLU/UPC can be linked to a maximum
of 5 PLUs.
Programming so that PLU 25, 26 and 27 are linked to PLU 21
Programming of PLU levels and direct PLU keys
You can assign PLU codes to fixed keys in each PLU level and use those keys as direct PLU key.
For assigning a PLU level, press the
l
,
¬
,
Ò
, or key or enter level number and press the
ä
key.
For example, if you want to assign PLU level 1 and key no. 1 to a PLU code, press the
l
key and enter 1
before entering the PLU code.
For key no. position, refer to section “3 Standard key number layout” in chapter “KEYBOARD”.
• PLU codes must have already been defined.
• The key number placement is determined by your local Authorized SHARP Dealer.
Note
ä
2219
. @ @ t Ç
Key no.
(max. 3 digits)
Level no.
(1-5)
PLU code
(max. 5 digits)
To program the next sequential key no.
To program any key no.
Cancellation
l
¬
Ò
To keep the current level
L4
L5
Procedure
L5 L4
2219 PGM 2
Linked
PLUs
2220 . @
21 @ 25 t
26 t
27 t
Ç
Print Key operation
Example
Note
2220
. @ @ t Ç
PLU code
(max. 5 digits)
Linked PLU code
(max. 5 digits)
To program any PLU/UPC
Cancellation
To repeat up to 5 times
t
To program for the following PLU/UPC
t
Ä
UPC code
(6 to 13 digits)
Procedure
2220 PGM 2