Sharp ER-A520 - Manual (Page 22)

20
PRIOR TO ENTRIES
Before registrations, insert the operator key into the mode switch and turn it to the REG position and check the
following items:
Receipt and journal paper rolls
If the receipt and journal paper rolls are not set in the machine or there are low rolls, install new ones according
to section “4. Installing and removing the paper rolls” under “OPERATOR MAINTENANCE.”
Receipt ON/OFF function
You can disable receipt printing in the REG mode to save paper using the receipt function. To disable receipt
printing, press the
q key in the OP X/Z position. This key toggles the receipt printing status ON and OFF.
To check the receipt printing status, turn the mode switch to the OP X/Z position or press the c key in the REG
mode. When the function is in the OFF status, the receipt off indicator “_” illuminates.
Your register will print reports regardless of the receipt state. This means that the receipt roll must
be installed even when the receipt state is “OFF” when taking reports.
Cashier/Server assignment
The ER-A520 requires a cashier to be assigned prior to operational item entries. The ER-A530 enforces that a
server must enter their code into the register. Depending on register settings, it is possible to keep the same
cashier/server code assigned when the same cashier/server is to be used for all transactions within a set period.
As previously mentioned, there are two variants to consider for the display and print of the cashier/server codes.
The operation entries depend on how the register has been programmed. To determine which
selections should be considered, please consult your local dealer.
Note
Note
Preparations for entries 1
FOR THE OPERATOR
Cashier/Server code
(“ ” is printed in Variant 2.)
Cashier/Server name
Logo message or graphic logo
(varies depending on
programming.)
✱ ✱ ✱ ✱